Reproduction A/C line grommet for Datsun 280Z. This grommet fits on the A/C hard line that runs behind the cylinder head on the firewall for Datsun 280Z.
Reproduction wiring harness clip for the firewall on Datsun 240Z, 260Z and 280Z, 1970-78. Fits hole size of 8mm.
Reproduction wiring harness clip for the firewall on Datsun 240Z, 260Z and 280Z, 1970-78. Fits hole size of 8mm.
Reproduction wiring harness clip for the firewall on Datsun 240Z, 260Z and 280Z, 1970-78. Fits hole size of 8mm.
New reproduction rocker panel hole plug. These plugs function great for plugging the holes and keeping moisture and debris out. The 240Z had two plugs in each rocker (4 total)...
New reproduction rocker panel hole plug. These plugs function great for plugging the holes and keeping moisture and debris out. The 240Z had two plugs in each rocker (4 total)...
Side marker lens gasket for Datsun 280ZX, 1979-83. Side marker lights are located on the front fenders and rear qaurters, four lenses per car. Will fit front or rear side markers.
Reproduction front turn signal/parking lamp gasket for Datsun 280ZX, 1979-81. This is the lense located in the front of the car.
Reproduction front turn signal/parking lamp gasket for Datsun 280ZX, 1979-81. This is the lense located in the front of the car.
Reproduction rubber bumper for the hatch. This rubber bumper will fit 1979-83 Datsun 280ZX. Two per vehicle.
Reproduction rubber bumper for the hatch. This rubber bumper will fit 1979-83 Datsun 280ZX. Two per vehicle.
New throttle shaft to firewall boot. This rubber boot will fit Datsun 240Z, 1970-73. The accelerator boot mounts in the firewall and the accelerator rod passes through it.
New fender to body seal for right or left side on Datsun 240Z, 260Z and 280Z, 1970-78. This seal is located under the front fender at the top edge. Rubber is held in place with...
New reproduction rear hatch rubber bumper. Fits Datsun 280Z 1977-78. These bumpers go about 1/2 way up in the rear hatch area where the hatch contacts the body. Two required per...
New OEM genuine Nissan rubber plug for spare tire area. Early cars only had one plug here and later cars had two plugs. This hole plug will fit Datsun 240Z, 260Z and 280Z,...
New OEM genuine Nissan rubber plug for the floor pan on Datsun 510 1968-73. 35mm O.D., Fits hole size approx 1" (25mm). Thick rubber.
New OEM Nissan wiper linkage cup for Datsun 280ZX, 1979-83. Plastic cup that connects the wiper arm linkage to the ball.
Metric thread file for repairing male threads. Pitch specification: Metric 0.75, 1.00, 1.25, 1.50, 1.75, 2.00, 2.50, 3.00